Digirig Mobile - Integrated Digital Modes Interface for Amateur Radio (Rev 1.9)

Digirig Mobile is a all-in-one open source digital modes interface for amateur radio.

• enjoy FT8, JS8Call, SSTV, PSK31, RTTY, CW decoders and other popular digital modes.
• Interface works with WSJT-X, Fldigi, Winlink, Yoniq, SSTV and other ham radio software including CAT apps like omnirig, flrig etc.
• combines audio codec, serial CAT interface and PTT switch
• supports full featured CAT interface: PTT, bands, tuning etc. (not just VOX based PTT)
• uses a single USB connection to computer minimizing the cables mess
• serial computer aided transceiver (CAT) port can be configured for logic levels, RS-232, CI-V or TX-500 (learn more at digirig website)
• works with all major OS flavors: Windows, MacOS and Linux
• permanently available independently from CAT port an open-collector PTT switch controlled by RTS signal of the COM port to interface HTs and mobile radios
• axillary connection points to CM108 codec - for simple Allstar homebrew node builds
• uses widely supported CP2102 serial interface (driver available at Silicon Labs website) and CM108 audio codec (generic audio device - no driver necessary)
• small rugged aluminum enclosure ideal for mobile operations
• interfaces the transceiver using widely available 3.5mm jacks (TRRS) for simple homebrew cable builds
• growing collection of pre-made cables including popular Icom, Yaesu, Elecraft, Baofeng, Xiegu transceivers
• isolation can be easily added using inexpensive USB isolator dongle

This listing does not include cables. USB cable is a standard Micro USB-C cord which must support both power/charging and data. You will have to make or purchase* the rig side cords for your specific radio

*refer to the digirig website for connection pinout and pre-made cable options.

Notes regarding the interface configuration:

• PTT option is always available independently from CAT and it works with any radio
• CAT configuration is done with solder jumpers and can not be changed operationally
• Digirig's default configuration for serial CAT is 3.3V logic levels. If the interface is ordered together with the transceiver cables and there is no ambiguity the configuration will be changed to match the cables. Please use order notes field or follow up with the email if you have a specific preference.
• Learn more about CAT configurations on digirig website

73 de K0TX