Parent Unit for Video Baby Monitor V24US

IMPORTANT: Two Parent Units cannot be paired to the same camera/s - this unit is only a replacement and should not be purchased/used as a second/additional parent unit to your existing monitor

To pair this new Parent Unit to your existing camera/s, follow the procedure below:

Note: Before you begin pairing, be sure to have the Baby and Parent Units side by side and turned on.

On the Parent Unit press the MENU/Exit key and the menu screen will be displayed.

Press the LEFT key or RIGHT key until the camera icon is highlighted in red then press UP key or DOWN key to select the desired camera to pair.

Press OK key to start the pairing.

Camera icon will start flashing searching for the camera to be paired with. While the icon is flashing, press and hold the PAIR button in the back of Baby Unit until the connection is established.

Once paired, an image from the paired camera will display on the screen.

If unsuccessful, please repeat above steps.

Press the MENU/Exit key to Exit.

Note: If there is more than one camera to be paired, repeat the above steps for each camera individually.

CAMERA VIEW - SWITCHING BETWEEN THE PAIRED CAMERAS:

This function is only available when two or more cameras are paired. The following steps should be performed on the Parent Unit:

Press OK key to switch the view to the next paired camera.

On the top of the LCD display you will see the number of the camera it is connected to.

Do not try switching between the cameras through the menu, as it is intended for Pairing purposes only. Use the OK button instead.

AUTOMATIC SCAN (LOOP) MODE:

You can also chose the SCAN (loop) mode and each paired camera will be displayed on the screen for 10 seconds and then the screen will automatically change to the next paired camera.

Press OK key several times until you will see the loop sign on the top of the LCD screen.